1. Prepare Your Walls:

1. Start by cleaning the walls thoroughly to remove any dust, dirt, or grease. This will ensure better adhesion.
2. If there are any holes or uneven surfaces, fill them in and sand them down to create a smooth surface.

2. Measure and Cut the Wallpaper:

1. Measure the height and width of the wall you'll be covering with the wallpaper.
2. Use these measurements to cut the wallpaper panels, leaving a few inches of excess at the top and bottom to allow for adjustments.

3. Peel Off the Backing:

1. Begin at one corner of the wallpaper panel and slowly peel off the backing, revealing the adhesive side.

4. Position and Apply the Wallpaper:

1. Carefully position the wallpaper panel against the wall, starting from the top.
2. Use a wallpaper smoothing tool or a clean cloth to gently press the wallpaper onto the wall, working your way down to the bottom.
3. Smooth out any air bubbles or wrinkles as you go to ensure a flat, even application.

5. Trim Excess Wallpaper:

1. Once the panel is fully applied, use a sharp utility knife or scissors to trim any excess wallpaper at the top, bottom, and sides.
2. Take care to make clean, straight cuts for a polished finish.

6. Repeat the Process:

1. Continue applying the wallpaper panels, aligning the patterns as necessary, until the entire wall is covered.

7. Final Touches:

1. Once all the wallpaper panels are installed, go over the entire surface with a wallpaper smoother or clean cloth to ensure strong adhesion and remove any remaining air bubbles.
2. Allow the wallpaper to set and dry completely before moving or placing furniture against the wall.

8. Enjoy Your New Look:

Step back and admire your newly transformed space! Self-adhesive wallpaper offers a quick and easy way to update the look of any room, giving it a fresh and stylish makeover.